Buildresult: linus/mips-allnoconfig/mips-gcc8 built on Oct 25 2022, 03:01

kisskb

Revisions | Branches | Compilers | Configs | Build Results | Build Failures |

Status:	OK
Date/Time:	Oct 25 2022, 03:01
Duration:	0:00:23.271451
Builder:	ka4
Revision:	Merge tag 'pci-v6.1-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci (`041bc24d867a2a577a06534d6d25e500b24a01ef)`
Target:	linus/mips-allnoconfig/mips-gcc8
Branch:	linus
Compiler:	mips-gcc8 (mips-linux-gcc (GCC) 8.5.0 / GNU ld (GNU Binutils) 2.36.1)
Config:	allnoconfig (download)
Log:	Download original No warnings found in log. Full Log # git rev-parse -q --verify 041bc24d867a2a577a06534d6d25e500b24a01ef^{commit} 041bc24d867a2a577a06534d6d25e500b24a01ef already have revision, skipping fetch # git checkout -q -f -B kisskb 041bc24d867a2a577a06534d6d25e500b24a01ef # git clean -qxdf # < git log -1 # commit 041bc24d867a2a577a06534d6d25e500b24a01ef # Merge: c440f9969523 0e00a3aeae25 # Author: Linus Torvalds <torvalds@linux-foundation.org> # Date: Tue Oct 11 11:08:18 2022 -0700 # # Merge tag 'pci-v6.1-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci # # Pull pci updates from Bjorn Helgaas: # "Resource management: # # - Distribute spare resources to unconfigured hotplug bridges at # boot-time (not just when hot-adding such a bridge), which makes # hot-adding devices to docks work better. # # - Revert to a BAR assignment inherited from firmware only when the # address is actually reachable via any upstream bridges, which fixes # some cases where firmware doesn't configure all devices. # # - Add a sysfs interface to resize BARs so this can be done before # assigning devices to a VM through VFIO. # # Power management: # # - Disable Precision Time Management for all devices on suspend to # enable lower-power PM state. We previously did this just for Root # Ports, which isn't enough because downstream devices can still # generate PTM messages, which cause errors if it's disabled in the # Root Port. # # - Save and restore the ASPM L1 PM Substates configuration for # suspend/ resume. Previously this configuration was lost, so L1.x # states likely stopped working after resume. # # - Check whether the L1 PM Substates Capability exists. If it didn't # exist, we previously read junk and tried to configure L1 Substates # based on that. # # - Fix the LTR_L1.2_THRESHOLD computation, which previously set a # threshold for entering L1.2 that was too low in some cases. # # - Reduce the delay after transitions to or from D3cold by using # usleep_range() rather than msleep(), which often slept for ~19ms # instead of the 10ms normally required. The spec says 10ms is # enough, but it's possible we could trip over devices that need a # little more. # # Error handling: # # - Work around a BIOS bug that caused Intel Root Ports to advertise a # Root Port Programmed I/O (RP PIO) log size of zero, which caused # annoying warnings and prevented the kernel from dumping log # registers for DPC errors. # # Qualcomm PCIe controller driver: # # - Add support for SC8280XP and SA8540P host controllers and SM8450 # endpoint controller. # # - Disable Master AXI clock on endpoint controllers to save power when # link is idle or in L1.x. # # - Expose link state transition counts via debugfs to help debug # issues with low-power states. # # - Add auto-loading module support. # # Synopsys DesignWare PCIe controller driver: # # - Remove a dependency on ZONE_DMA32 by allocating the MSI target page # differently. There's more work to do related to eDMA controllers, # so it's not completely settled" # # * tag 'pci-v6.1-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci: (71 commits) # PCI: qcom-ep: Check platform_get_resource_byname() return value # PCI: qcom-ep: Add support for SM8450 SoC # dt-bindings: PCI: qcom-ep: Add support for SM8450 SoC # dt-bindings: PCI: qcom-ep: Define clocks per platform # PCI: qcom-ep: Make PERST separation optional # dt-bindings: PCI: qcom-ep: Make PERST separation optional # PCI: qcom-ep: Disable Master AXI Clock when there is no PCIe traffic # PCI: Expose PCIe Resizable BAR support via sysfs # PCI/ASPM: Correct LTR_L1.2_THRESHOLD computation # PCI/ASPM: Ignore L1 PM Substates if device lacks capability # PCI/ASPM: Factor out L1 PM Substates configuration # PCI: qcom-ep: Gate Master AXI clock to MHI bus during L1SS # PCI: qcom-ep: Expose link transition counts via debugfs # PCI: qcom-ep: Disable IRQs during driver remove # PCI/ASPM: Save L1 PM Substates Capability for suspend/resume # PCI/ASPM: Refactor L1 PM Substates Control Register programming # PCI: qcom-ep: Make use of the cached dev pointer # PCI: qcom-ep: Rely on the clocks supplied by devicetree # PCI: qcom-ep: Add kernel-doc for qcom_pcie_ep structure # phy: freescale: imx8m-pcie: Fix the wrong order of phy_init() and phy_power_on() # ... # < /opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux-gcc --version # < /opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux-ld --version # < git log --format=%s --max-count=1 041bc24d867a2a577a06534d6d25e500b24a01ef # < make -s -j 120 ARCH=mips O=/kisskb/build/linus_mips-allnoconfig_mips-gcc8 CROSS_COMPILE=/opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux- allnoconfig # < make -s -j 120 ARCH=mips O=/kisskb/build/linus_mips-allnoconfig_mips-gcc8 CROSS_COMPILE=/opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux- help # make -s -j 120 ARCH=mips O=/kisskb/build/linus_mips-allnoconfig_mips-gcc8 CROSS_COMPILE=/opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux- olddefconfig # make -s -j 120 ARCH=mips O=/kisskb/build/linus_mips-allnoconfig_mips-gcc8 CROSS_COMPILE=/opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux- Completed OK # rm -rf /kisskb/build/linus_mips-allnoconfig_mips-gcc8 # Build took: 0:00:23.271451

© Michael Ellerman 2006-2018.