# git rev-parse -q --verify 041bc24d867a2a577a06534d6d25e500b24a01ef^{commit}
041bc24d867a2a577a06534d6d25e500b24a01ef
already have revision, skipping fetch
# git checkout -q -f -B kisskb 041bc24d867a2a577a06534d6d25e500b24a01ef
# git clean -qxdf
# < git log -1
# commit 041bc24d867a2a577a06534d6d25e500b24a01ef
# Merge: c440f9969523 0e00a3aeae25
# Author: Linus Torvalds <torvalds@linux-foundation.org>
# Date:   Tue Oct 11 11:08:18 2022 -0700
# 
#     Merge tag 'pci-v6.1-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci
#     
#     Pull pci updates from Bjorn Helgaas:
#      "Resource management:
#     
#        - Distribute spare resources to unconfigured hotplug bridges at
#          boot-time (not just when hot-adding such a bridge), which makes
#          hot-adding devices to docks work better.
#     
#        - Revert to a BAR assignment inherited from firmware only when the
#          address is actually reachable via any upstream bridges, which fixes
#          some cases where firmware doesn't configure all devices.
#     
#        - Add a sysfs interface to resize BARs so this can be done before
#          assigning devices to a VM through VFIO.
#     
#       Power management:
#     
#        - Disable Precision Time Management for all devices on suspend to
#          enable lower-power PM state. We previously did this just for Root
#          Ports, which isn't enough because downstream devices can still
#          generate PTM messages, which cause errors if it's disabled in the
#          Root Port.
#     
#        - Save and restore the ASPM L1 PM Substates configuration for
#          suspend/ resume. Previously this configuration was lost, so L1.x
#          states likely stopped working after resume.
#     
#        - Check whether the L1 PM Substates Capability exists. If it didn't
#          exist, we previously read junk and tried to configure L1 Substates
#          based on that.
#     
#        - Fix the LTR_L1.2_THRESHOLD computation, which previously set a
#          threshold for entering L1.2 that was too low in some cases.
#     
#        - Reduce the delay after transitions to or from D3cold by using
#          usleep_range() rather than msleep(), which often slept for ~19ms
#          instead of the 10ms normally required. The spec says 10ms is
#          enough, but it's possible we could trip over devices that need a
#          little more.
#     
#       Error handling:
#     
#        - Work around a BIOS bug that caused Intel Root Ports to advertise a
#          Root Port Programmed I/O (RP PIO) log size of zero, which caused
#          annoying warnings and prevented the kernel from dumping log
#          registers for DPC errors.
#     
#       Qualcomm PCIe controller driver:
#     
#        - Add support for SC8280XP and SA8540P host controllers and SM8450
#          endpoint controller.
#     
#        - Disable Master AXI clock on endpoint controllers to save power when
#          link is idle or in L1.x.
#     
#        - Expose link state transition counts via debugfs to help debug
#          issues with low-power states.
#     
#        - Add auto-loading module support.
#     
#       Synopsys DesignWare PCIe controller driver:
#     
#        - Remove a dependency on ZONE_DMA32 by allocating the MSI target page
#          differently. There's more work to do related to eDMA controllers,
#          so it's not completely settled"
#     
#     * tag 'pci-v6.1-changes' of git://git.kernel.org/pub/scm/linux/kernel/git/helgaas/pci: (71 commits)
#       PCI: qcom-ep: Check platform_get_resource_byname() return value
#       PCI: qcom-ep: Add support for SM8450 SoC
#       dt-bindings: PCI: qcom-ep: Add support for SM8450 SoC
#       dt-bindings: PCI: qcom-ep: Define clocks per platform
#       PCI: qcom-ep: Make PERST separation optional
#       dt-bindings: PCI: qcom-ep: Make PERST separation optional
#       PCI: qcom-ep: Disable Master AXI Clock when there is no PCIe traffic
#       PCI: Expose PCIe Resizable BAR support via sysfs
#       PCI/ASPM: Correct LTR_L1.2_THRESHOLD computation
#       PCI/ASPM: Ignore L1 PM Substates if device lacks capability
#       PCI/ASPM: Factor out L1 PM Substates configuration
#       PCI: qcom-ep: Gate Master AXI clock to MHI bus during L1SS
#       PCI: qcom-ep: Expose link transition counts via debugfs
#       PCI: qcom-ep: Disable IRQs during driver remove
#       PCI/ASPM: Save L1 PM Substates Capability for suspend/resume
#       PCI/ASPM: Refactor L1 PM Substates Control Register programming
#       PCI: qcom-ep: Make use of the cached dev pointer
#       PCI: qcom-ep: Rely on the clocks supplied by devicetree
#       PCI: qcom-ep: Add kernel-doc for qcom_pcie_ep structure
#       phy: freescale: imx8m-pcie: Fix the wrong order of phy_init() and phy_power_on()
#       ...
# < /opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux-gcc --version
# < /opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux-ld --version
# < git log --format=%s --max-count=1 041bc24d867a2a577a06534d6d25e500b24a01ef
# < make -s -j 120 ARCH=mips O=/kisskb/build/linus_64r6el_defconfig_mips-gcc8 CROSS_COMPILE=/opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux-  64r6el_defconfig
# < make -s -j 120 ARCH=mips O=/kisskb/build/linus_64r6el_defconfig_mips-gcc8 CROSS_COMPILE=/opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux-  help
# make -s -j 120 ARCH=mips O=/kisskb/build/linus_64r6el_defconfig_mips-gcc8 CROSS_COMPILE=/opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux-  olddefconfig
# make -s -j 120 ARCH=mips O=/kisskb/build/linus_64r6el_defconfig_mips-gcc8 CROSS_COMPILE=/opt/cross/kisskb/korg/gcc-8.5.0-nolibc/mips-linux/bin/mips-linux-  
/kisskb/src/arch/mips/boot/dts/img/boston.dts:128.19-178.5: Warning (pci_device_reg): /pci@14000000/pci2_root@0,0,0: PCI unit address format error, expected "0,0"
Completed OK
# rm -rf /kisskb/build/linus_64r6el_defconfig_mips-gcc8
# Build took: 0:01:09.875652